[. . . ] This appliance is intended for use up to a maximum height of 2000 metres above sea level. If the appliance is being installed under a hob, refer to the assembly instructions for the hob. [. . . ] Carry out all cut-out work on the furniture unit and worktop before fitting the appliances. Otherwise, the correct operation of electrical components may be adversely affected. Secure freestanding units to the wall using standard, commercially available brackets A. 1 To ventilate the appliance, there must be a gap of 20 mm between the intermediate floor and the wall. The gap between the worktop and the appliance must not be closed using additional battens. Ensure that there is sufficient clearance B for the front panel and its handles. 3 To ventilate the appliance, there must be a gap of 20 mm between all intermediate floors and the wall. Only fit the appliance up to a height which allows accessories to be easily removed. Connecting the appliance to the power supply The appliance is fitted with a plug and must only be connected using the power cable provided. The fuse protection must correspond to the power rating specified on the appliance's rating plate and to local regulations. The appliance must only be connected to a protective contact socket which has been correctly installed. If the plug is no longer accessible following installation, an allpole disconnection switch must be present on the installation side with a contact gap of at least 3 mm. [. . . ] Open the appliance door slightly and unscrew the left and right- Lift the appliance slightly and pull it out completely. A faulty power cable must only be replaced by a special replacement power cable from the manufacturer or from aftersales service. [. . . ]